Skip to main content
Zanussi | Help and Support

Oven displays error message F1

For appliances with a pyrolytic function:

If the oven's display shows error message F1 it indicates that the oven door cannot close because the pyrolytic function is ON.

  • Check if the top part of the door is intact and secured properly to the door.
  • Another possible cause: the door was recently cleaned or detached. Refer to the user manual to find out the correct assembly instructions for the door. (If you do not have your user manual, refer to Where can I find the user manual for my appliance?).
  • If this doesn’t fix the problem, we recommend contacting an Authorized Service Center.
For appliances without a pyrolytic function:

If the oven's display shows error message F1 the possible cause is an electronic fault.

  • To investigate the problem, we recommend contacting an Authorized Service Center.

 

2017-08-16_1122.png

To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.

When contacting us, please have the following information to hand. You will find this information on the manufacturer’s data plate:

  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

Data plate with model number, product number/PNC, ELC and serial number:

modelnoexplanation1.gif
  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

[3–9999] Where will I find the data plate on my product? 

NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.

Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.

  • Report error code: BS

Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.

You can request a visit by one of our engineers by clicking on the link below.