Skip to main content
Zanussi | Help and Support

Dishwasher short-circuits, burns out fuses or trips RCD circuit breakers

When an RCD circuit breaker trips or a fuse burns out when you switch the appliance on or off, this is due to leakage to ground or a short-circuit.

  • If several appliances are connected to the same fuse circuit, this could cause the fuse to burn out or the RCD circuit breaker to trip.
  • Plugging the appliance into another fuse circuit should resolve this issue.

Warning: 

  • You should not connect a washing machine and a tumble dryer to the same fuse circuit.
  • The power required by the two appliances combined exceeds the safe capacity of standard fuse circuits.
  • Never use an extension cable to connect appliances, as this can cause a short-circuit or fire hazard.

If the above suggestions do not resolve the problem, contact an Authorized Service Center.

 

2017-08-16_1122.png

To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.

When contacting us, please have the following information to hand. You will find this information on the manufacturer’s data plate:

  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

Data plate with model number, product number/PNC, ELC and serial number:

modelnoexplanation1.gif
  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

[3–9999] Where will I find the data plate on my product? 

NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.

Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.

  • Report error code: CR

Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.

You can request a visit by one of our engineers by clicking on the link below.