The dryer calculates needed time according to the load. The time on the display is estimate.
- The load may be too large and too wet.
- Try another spin cycle that matches the load and make sure the clothing is dry enough for selected drying cycle.
This problem may be caused by dirty filters. See the user manual for how to clean and maintain your appliance. (If you do not have your user manual, refer to Where can I find the user manual for my appliance?).
- Check the filters by holding them up to the light and see if they are porous.
- If no water passes through the filters, clean them and check again.
- If water still does not pass through the filters, replace them.
Filters and accessories are available via the Webshop. (You can visit our Webshop by clicking on the link below).
Is the ambient temperature between 5°C and 35°C?
If the ambient temperature is too low or too high, the tumble dryer may not operate correctly.
- Place the dryer in a room which has a suitable temperature.
- If the dryer is located in a room, make sure that the temperature of the room is between 5°C and 35°C.
- If the room temperature is not within this range, the tumble dryer may not operate correctly and will not heat up.
- Heat the room in which the tumble dryer is situated until it reaches a suitable temperature, or move the dryer to another room which is at a suitable temperature.
Check whether the appliance is getting hot:
Before you book an engineer, it is important to check if the appliance’s heating system is working.
- Firstly, clean the appliance and then start a timed cycle of at least 120 minutes with no load.
- After one hour, open the door and check whether the drum is hot inside (with at least 20 minutes remaining on the display).
- If the inside of the drum is hot, the heating system is working. In tumble dryers fitted with a heat pump, you can often also hear whooshing or sloshing noises from the appliance when it stops.
- If the appliance is still not hot after an hour of the program, we recommend requesting a visit by a service engineer. (Report error code: JN).
To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.
When contacting us, please have the following information to hand. You will find this information on the manufacturer’s data plate:
- Model number
- Product number (PNC)
- ELC number
- Serial number
Data plate with model number, product number/PNC, ELC and serial number:
NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
- Report error code: JJ (Or according to the instructions listed above).
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
You can request a visit by one of our engineers by clicking on the link below.